DeWalt DW088 Traduction De La Notice D'instructions Originale page 61

• Place the clamp jaw around the wall track and release the clamp to
close the clamp jaws shut on the track.
To mount the wall mount to a wall, proceed as follows:
• Hold the tool at the desired position against the wall and mark the
location of the mounting hole on the wall.
• Drill a hole at the marked location.
• Insert a corresponding plug into the hole.
• Hold the tool in front of the plug.
• Turn a screw into the mounting hole (16).
Adjusting the Tool
• To initiate the leveling procedure, switch on the tool. The level and/
or plumb orientation is correctly adjusted as long as the laser beams
remain on.
• The laser beams start flashing to indicate that the tool has been set up
at a slope that is beyond the self-leveling range of 4°. Switch the tool
off, re-adjust the tool set-up within the self-leveling range and switch the
tool on again.
Aligning the Laser Line (fi g. D)
• Align the laser line of either one of the laser beams with the position
mark. Move the tool as required.
OPERATION
WARNING! Do not place the laser in a position which
may cause anyone to intentionally or unintentionally
stare into the laser beam. Serious eye injury may result from
staring at the beam.
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
E N G L I S H
59