DeWalt DW088 Traduction De La Notice D'instructions Originale page 64

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 73
E N G L I S H
detector is "on grade". In the narrow setting, this tolerance is reduced for
more accurate indication of "on grade".
For the most accurate results, start the work using the wide setting and
finish in the narrow setting.
Magnets
The magnets (24) allow the detector to be mounted to the metal tracks
during the installation of a suspended ceiling.
DETECTOR OPERATION (FIG. F)
1. Set up and position the laser.
2. Turn the detector on by pressing the power button (21).
3. Position the detector so that the sensor window (25) is facing the
laser beam. Move the detector up or down within the approximate
area of the beam, until you have centered the detector. For
information about the display window indicators and the audible
signal indicators, refer to the table titled Indicators.
Above
Slightly Above
Grade
fast
beep
4. Use the marking notches (20) to accurately mark the position of the
laser beam.
MOUNTING ON A GRADE ROD (FIG. F, G)
1. To secure your detector to a grade rod, first attach the detector to the
clamp by pushing in on the clamp latch (26). Slide the tracks (27) on
62
INDICATORS
On
Slightly below
Grade
Grade
Grade
fast
steady
slow
beep
tone
beep
Below
Grade
slow
beep

Publicité

Table des Matières
loading

Table des Matières