Mounting And Connection; Mounting The Device - HQ Power VDPLBPX Mode D'emploi


Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Due to constant product improvements, the actual product appearance might differ from the shown
images.

Product images are for illustrative purposes only.

Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.

Keep this manual for future reference.
4. Features
A new stage or decorating LED effect with individual colour-changing possibilities via DMX or pixel control
via Kling-Net. The ArKaos LEDMaster Mapping Mode allows you to easily use the pixel mapping control. One
set exists of 1 controller with 5 outputs and 10 LED ball strings with 5 LED balls each. Each output on the
controller can be 6 m long. The auto-mode features up to 30 built-in programmes with speed control.

these decorative LED orbs are a flexible and innovative solution for all kind of creations and for a
scenography set with dynamic and graphical contents

composed by spheres of LEDs connected in a string with pixel control

with a resolution of 10 x 5 pixels you get a pitch of 200 mm (total of 50 spheres)

can be controlled by DMX, master/slave or video mapping via the Kling-Net protocol

due to the spherical shape and the translucent material of the globes, the projection angle is 360°
which allows multi-directional and 3D animations

comes with carrying bag for easy transportation

DMX-controlled via 150, 225, 300, 375 or 450 channels depending on the length of the strings
5. Overview
Refer to the illustrations on page 2 of this manual.
1
signal connector male
2
signal connector female
3 signal cable termination
4 control panel
5 connection for male connector
6 LED ball
6.

Mounting and Connection

Choose a suitable mounting spot. Mount the device in the desired angle using the included bracket.
Connect the power cord to the mains. Disconnect after use.
6.1

Mounting the Device


Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.

The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.

The installation must always be secured with a secondary attachment e.g. a safety cable.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.

Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.

Make sure there is no flammable material within a 0.5 m radius of the device.
V. 02 – 30/06/2015
VDPLBPX
7
power output
8
DMX output
9 DMX input
10 on-off switch
11 power input
7 ©Velleman nv