Connecting The Device; Control Panel - HQ Power VDPLBPX Mode D'emploi


Have a qualified electrician carry out the electric connection.

Connect the device to the mains with the power plug. All devices must be powered directly off a
grounded switched circuit. Do not connect to a dimmer pack.

The device has a power output to supply power to another device. When connecting several devices
in a daisy chain via this output, make sure that the total current does not exceed the power line's
nominal current. Use power cables with an adequate section.

The installation has to be approved by an expert before the device is taken into service.
6.2

Connecting the Device

Assembly
Refer to the illustrations on page 2 of this manual.
1. Take out your VDPLBPX from the package. We recommend assembling the device on a flat surface.
2. Connect each string to the controller. If desired, you can connect multiple strings into one output,
provided that the total length of a single string does not exceed 6 m.
3. Make sure to terminate each string with a signal cable termination.
Power
Connect the device to the mains with the power plug.
Power all devices directly off a grounded switched circuit.
Do not connect the device to a rheostat or dimmer circuit, even when using the rheostat or dimmer
channel solely for 0 % to 100 % switching.

Have a qualified electrician carry out the electric connection.
DMX-512 Connection

When applicable, connect an XLR cable to the female XLR output of a controller (not incl.) and the
other side to the male XLR input of the device. Multiple devices can be linked through serial linking.
The linking cable shall be a dual core, screened cable with XLR input and output connectors.

A DMX terminator is recommended for installations where the DMX cable has to run a long distance
or is in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the
digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω
resistor between pins 2 and 3, which is then plugged into the XLR output socket of the last device in
the chain.
7. Operation
The device can be used in the following modes:

stand-alone mode

master/slave

with a DMX-512 controller.
7.1

Control Panel

Access the control panel functions using the four panel buttons located around the display:
Button Function

MENU


ENTER


UP


DOWN

Menu
Refer to the illustrations on page 3 of this manual.
V. 02 – 30/06/2015
access the menu
return to a previous menu option
select menu option
store the current menu or option within the menu
scroll through the menu options in ascending order
increase value
scroll through the menu options in descending order
decrease value
VDPLBPX
8 ©Velleman nv