Intake Air Cooling Vent - elem Garden Technic DCBT33D Manuel D'utilisation

INTAKE AIR COOLING VENT

Check the intake air cooling vent and the area
around the cylinder cooling fins
IMPORTANT
Note that failing to do so could cause the muffler to become overheated,and that
this in turn could cause the brushcutter to catch on fire.
8.MAINTENANCE
GEAR CASE
Supply multi-purpose grease at every 25 hours of use.
AFTER 100 HOURS OF USE
MUFFLER
1.Remove the muffler, insert a screwdriver into the vent, and wipe away any
carbon buildup. Wipe away any carbon buildup on the muffler exhaust vent
ADJUSTING CARBURETOR
A wrong adjustment may cause damage to your unit. If the engine does not
run well after adjusting the carburetor, please contact the shop where you
purchased the product.
IDLE ADJUSTMENT SOREW
This is the screw to adjust the engine rotation
when the throttle lever is set to the lowest
speed position. If you turn
right(clockwise),rotation increases, and left
(counterclockwise) decreases.
(1)Idle adjustment screw (2)High (3)Low
MAINTENACE BEFORE STORAGE
1.Brushing off dirt form the machine, check
damage or slack of each part. If you find out
abnormalities, repair them for the next use.
17