Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Check the Installation
Belts must be tight.
Place carrier in the base and ensure blue line is
levelled with ground.
Base should not move side to side more than
25 mm (1 in.) at belt path.
Belts and buckles must not interfere with
attachment of carrier to base.
Vehicle belts must lay flat under lock off.
• It is acceptable to install with both UAS - angle towel/noodle (lower
attachments) and the vehicle belt.
1
-
After child is properly secured in carrier, press carrier on base and
listen for a click. Pull on carrier to verify proper installation.
Your child may not be protected in the event
of a crash or sudden stop if you do not check
and verify that the seat is securely attached.
2
- To release the infant child restraint, pull the infant
child restraint up while squeezing the infant child
restraint release button.
34 PIPA instructions
Publicité
Table des Matières
