Child Requirements - Nuna pipa Mode D'emploi

1
- To adjust the handle position, squeeze handle
buttons on both sides and rotate.
2
- Rotate handle until it clicks into any of the 3
positions. In the vehicle, the handle MUST BE
PLACED (LOCKED) IN POSITION 1 ONLY.
Be sure handle is locked in the carry position
before lifting carrier by handle. An unlocked
handle could move unexpectedly, causing
injury to child.
Handle MUST NOT contact the vehicle interior
when installed.

Child Requirements

3
-
Weight: 1.8 to 15.9 kg (4 to 35 lb).
Height: less than 81 cm (32 inches).
Top of child's head is at least 25 mm (1 in.)
below top of carrier.
Infant insert
4
- The infant insert can be used as necessary
to provide a snug fit for small babies. The
low birth weight pillow (shown in green)
can be used in the infant insert for even
smaller babies, but should be removed once
unnecessary. The low birth weight pillow
should be removed once a snug fit can be
achieved without it, at approximately 5 kg (11 lb).
18 PIPA instructions