Franke CRYSTAL FMW 45 CR C Manuel D'installation Et Mode D'emploi page 14

EN
Cooking guide function
The Cooking guide function
appropriate cooking parameters according to
the food to be prepared and its weight.
X X
Select
preprogrammed food from the following
list:
P01
Ready-to-cook frozen food
P02
Ready-to-cook chilled food (combined function)
P03
Frozen pizza (combined function)
P04 Frozen pizza (traditional cooking)
P05
Fresh pizza
P06
Quiche
P07
Savoury tart
P08
Poultry
P09
Beef
P10
Pork
P11
Ready-to-cook chilled food (microwave)
P12 Fish
P13 Fresh fibrous vegetables
P14
Fresh vegetables
P15
Frozen vegetables
X X
Select the function
X X
Choose your food with
X X
Press
„ „
Depending on the food selected, a
weight (or a cooking time) is suggested
and flashes on the screen.
X X
Modify the required setting with
and
X X
Press
Note: Duration cannot be modified for P06
and P07.
X X
By pressing
end time setting (delayed start
X X
Modify it if required with
X X
Press
„ „
The oven starts.
Automatic defrost functions
The automatic defrost functions select the
appropriate cooking parameters according to
the food to be prepared and its weight.
FMW 45 CR C XS / FMW 45 CR C BK
selects the
. You must choose a
1
with
2
3
and
to confirm.
to confirm.
, you access the cooking
and
to confirm.
Select a pre-programmed food from the list
below:
P01
Defrosting meat, poultry and ready-to-cook dishes
P02
Defrosting fish
P03
Defrosting bread
X X
Select the automatic defrost function
X X
Select a programme and enter the weight
of the food with
X X
Press
X X
The delayed start cannot be used with
these positions.
Memory function
The memory function allows you to store 3
common cooking (or defrosting) programs,
which you can then use thanks to quick
selection.
Programming a memory key
X X
First programme a cooking mode of your
choice with
X X
Adjust the temperature and the power
(e.g.: 220°C) and then the cooking time
(e.g.: 25 minutes).
X X
Save your cooking program by holding
down the OK button until MEMO -1- flashes
in the display.
X X
Select one of the available memory
programs: 1 – 2 or 3 with
from one to the next.
X X
Press
„ „
A beep will confirm that the
programme has been saved.
Using a memory programme
X X
Select the function
„ „ MEMO will appear in the display.
X X
Choose the required MEMO 1 – 2 or 3 with
and
X X
Press
„ „
The programmed memory will be
).
displayed.
„ „
Press the
will turn on and the program will start.
Note: Follow the same procedure to replace
the previous programming. You can store all
functions except automatic programs.
– 14 –
and (in 50g steps).
to confirm.
1
(e.g. fan).
2
3
and
to confirm.
with 1
2
3
to go from one to the next.
to confirm.
button again; the oven
to go