General Safety Rules - CST/BERGER XP5S Consignes De Fonctionnement/Sécurité

WARNING
WARNING
This tool produces laser class 2M laser radiation and complies with 21 CFR
1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50,
dated June 24, 2007. This can lead to persons being blinded.
CAUTION Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
Do not direct the laser beam at persons or animals and do not stare into the laser beam
yourself.
DO NOT remove or deface any warning or caution labels. Removing labels increases the
risk of exposure to laser radiation.
Use of controls or adjustments or performance of procedures other than those specified in
this manual, may result in hazardous radiation exposure.
ALWAYS make sure that any bystanders in the vicinity of use are made aware of the dan-
gers of looking directly into the laser tool.
DO NOT place the laser tool in a position that may cause anyone to stare into the laser beam
intentionally or unintentionally. Serious eye injury could result.
ALWAYS position the laser tool securely. Damage to the laser tool and/or serious injury to
the user could result if the laser tool fails.
ALWAYS use only the accessories that are recommended by the manufacturer of your laser
tool. Use of accessories that have been designed for use with other laser tools could result
in serious injury.
DO NOT use this laser tool for any purpose other than those outlined in this manual. This
could result in serious injury.
DO NOT leave the laser tool "ON" unattended in any operating mode.
DO NOT disassemble the laser tool. There are no user serviceable parts inside. Do not

General Safety Rules

Read all instructions. Failure to follow all instructions listed
below may result in hazardous radiation exposure, electric shock,
fire and/or serious injury.
The following labels are on your tool for your convenience and
safety. They indicate where the laser light is emitted by the tool.
ALWAYS BE AWARE of their location when using the tool.
SAVE THESE INSTRUCTIONS
3