Kit Overview; Kit Contents; Required Tools - Pentair ULTRATEMP ETi Guide D'installation

4

Kit Overview

Before installing the UltraTemp ETi™ Hybrid Heater Fuel Gas Conversion Kit, please
verify that you have all items listed below.

Kit Contents:

11
10
3
2
1
Required Tools (not included in this kit)
You will need the following tools and instruments:
• 5/16" Socket Wrench or Nut Driver
• 2-1/2" Adjustable Wrench
• T20 Torx-head Driver
• Phillips-head Driver
• 3/16" Allen Wrench
• 1/8" NPT Barbed Fitting
• Pipe Sealant approved for use with natural gas or propane
• Pressure Gauge or Manometer with Range to 14" W.C. (High Pressure
Gauge)
• Differential Pressure Gauge or Slope Gauge (inclined manometer) capable of
reading to a resolution of 0.05" W.C. (Low Pressure Gauge)
• Flue-gas Analyzer Reading CO
Note: Do not attempt conversion without all tools listed above.
5
4 6 7
2
Item # Description
1 Burner
2 Air Orifice
3 Air Orifice Grill
4 Spark Electrode
5 Gas Orifice
6 Gas Orifice O-ring
7 Screw, Hex/Phillips (Qty. 2)
8 PVC Tubing, 7"
9 PVC Tubing, 12"
10 Installation Guide
11 Conversion Label
9
8