Product Overview; Intended Use; Noise & Vibration; Using The Tool - Pattfield Ergo Tools PE-600 PM Manuel D'instructions

Product overview

1 Auxiliary handle
2 Handle
3
Auxiliary handle screw
4
Base plate
5 Foam polishing pad
6 Speed dial
7 Power cord
8 On / Off switch

Intended Use

The tool is intended for polishing of plastic,
metal as well as coated surfaces. The tool is
not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Noise & Vibration
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 60745 and can be used to compare tools.
It may be used for a preliminary assessment
of exposure.
AUXILIARY HANDLE
1 Loosen the two
ry handle 1 by use of the 6 mm hex key.
Caution! Make sure the tool is
switched off and unplugged.
70 EN
screws 3 of the auxilia-

Using the tool

1. Apply the proper type and amount of pol-
ishing cream to the compounding pad or
to the foam polishing pad 5.
2. The rule of thumb is to start with a woolen
compounding pad and finish with a foam
polishing pad.
3. Place the tool on the surface so that the
complete foam polishing
tact. Make sure your surface can not slip.
4. To switch on the tool, switch on the on /
off switch 8. Start working, while holding
the tool firmly with both hands.
5. Move the tool slowly over the surface in
parallel lines, circles or crosswise move-
ments and successive passes.
6. To switch off the tool, switch off the on /
off switch 8.
Warning! Only switch the tool on
when the foam polishing pad is in
full contact with the surface.
Warning! The vibration emission
during actual use can differ from the
declared total value depending on the use
of the tool.
2 Set the auxiliary
sired position and tighten its two
screws 3 by use of the 6 mm hex key.
pad 5 is in con-
handle 1 to the de-