Product Overview; Intended Use; Technical Data; Using The Tool - Pattfield Ergo Tools PE-430ES Traduction De La Notice Originale

Product overview

1 On / Off switch
2 Speed dial
3
Sanding pad
4
Lock on button
5 Power cord
6 Dust box
7 Dust port

Intended Use

The tool is intended for dry sanding of wood,
plastic, metal, filler as well as coated surfaces.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.

Technical Data

Nominal voltage
Rated power
No-load speed (n )
0
Base plate (ø)
Orbit (ø)
Weight
Protection Class
Sound pressure level (L
Sound power level (L
Max. vibration emission (a
DUST BOX
1 To connect the dust box 6, align the two
nozzles of the dust box with the two
grooves inside the dust port 7.
Make sure the dust box is empty
and not clogged.
70 EN
)
pA
)
wA
)
h

Using the tool

1. Place the tool on the workpiece so that
the complete sanding paper is in contact.
Make sure your workpiece can not slip.
2. To switch on the tool, press and hold
the on / off switch 1. To lock the on / off
switch 1 in position, press the lock on
button 4 while the on / off switch
pressed. Start working, while holding the
tool firmly with both hands.
3. Move the tool slowly over the workpiece
in parallel lines, circles or crosswise
movements and successive passes.
4. To switch off the tool, press and release
the on / off switch 1.
Warning! Only switch the tool on
when the sanding paper is in full
contact with the workpiece.
230 V / ~50 Hz
430 W
5000 - 13000/min
125 mm
1 mm
2.15 kg
/ II
77 dB(A) / Uncertainty K = 3 dB(A)
88 dB(A) / Uncertainty K = 3 dB(A)
7.6 m/s / Uncertainty K = 1.5 m/s
2
2 When the dust box 6
turn it approx. 15° clockwise to click
it in place.
Never use the tool without the dust
box attached.
1 is
2
is fully inserted,