Technical Data - Pattfield Ergo Tools PE-600 PM Manuel D'instructions

POLISHING PAD
1 Remove the protective cap from the
thread of the base plate 4.
Attach the polishing foam
base plate 4.
Caution! Make sure the yellow
washer remains on the base plate.
3 With the 14 mm wrench in place, screw
the base plate 4
polisher.
Do not use the same polishing pad
for metal and coated surfaces.
SPEED SETTING
1 Use speed dial 6
speed.
Caution! Make sure not to cover the
ventilation slots during operation.

Technical Data

Nominal voltage
Rated power
No-load speed (n )
0
Diameter base plate
Spindle thread size
Weight
Protection Class
Sound pressure level (L
Sound power level (L
wA
Max. vibration emission (a
pad 5 to the
into the thread of the
to set the operation
)
pA
)
)
h,ID
2 Place the machine upside down on its
auxiliary handle.
Caution! Make sure the tool is
switched off and unplugged.
4 Make sure that the base
curely attached to the polisher and re-
move the 14 mm wrench.
2 The operation speed can be set in six
steps from:
1 = 1500/min - 6 = 6800/min
230 - 240 V / ~50 Hz
600 W
1500 - 6800/min
150 mm
M8
2.22 kg
/ II
80 dB(A) / Uncertainty K = 3 dB(A)
91 dB(A) / Uncertainty K = 3 dB(A)
<2.5 m/s / Uncertainty K = 1.5 m/s
2
plate 4 is se-
2
EN 71