Product Overview; Intended Use; Using The Tool - Pattfield Ergo Tools PE-300MFW Traduction De La Notice Originale

Product overview

1 On / Off switch
2 Auxiliary handle connector
3
Tool holder
4
Speed dial
5 Power cord
6 Clamping screw with washer

Intended Use

The tool is intended for sawing and cutting
wooden materials, plastic, gypsum, non-fer-
rous metals and fastening elements (e.g. nails,
staples). It is also suitable for working soft wall
tiles as well as for dry sanding and scraping
of small surfaces. It is especially suitable for
working close to edges and for flush cutting.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
AUXILIARY HANDLE
1 The auxiliary handle can be attached
to the auxiliary handle
either side of the tool.
86 EN

Using the tool

1. For sanding place the tool on the work-
piece so that the complete sanding paper
is in contact.
2. Make sure your workpiece can not slip
and switch the tool on at the on / off
switch 1.
3. Depending on the installed tool and the
type of work, set the desired operation
speed at the speed dial 4.
4. Start working, while holding the tool
firmly with both hands. Move the tool
to the workpiece and push it slow-
ly in the desired direction.
For scraping and sanding, move the
tool slowly over the workpiece in paral-
lel lines, circles or crosswise movements
and successive passes.
5. Switch the tool off at the on / off switch 1.
not to touch them. Burn hazard.
2
connector 2 on
mounted at the tool.
Warning! The installed tools may
become hot during use. Be careful
Screw the auxiliary handle into the
auxiliary handle connector 2.
For safe working conditions, make
sure the auxiliary handle is always