General Inspection - Haussmann SMS15A-10-DB Manuel D'utilisation

OPERATING INSTRUCTIONS
4) Adjust until the left-hand laser line is aligned
with the left-hand side of the blade.
5) Switch off the laser lights.
Using the laser line generator
WARNINGS
Do not stare directly at the laser beam.
Never aim the beam at any person or an object
other than the workpiece.
Do not deliberately aim the beam at personnel
and ensure that it is not directed towards the
eye of a person for longer than 0.25s.
Always ensure the laser beam is aimed at a stur-
dy workpiece without reflective surfaces. Wood
or rough coated surfaces are acceptable. Bright
reflective surfaces are not suitable for laser use
as the reflective surface could direct the beam
back at the operator.
Always remember to switch off the laser on/off
switch (2) after finishing a job. Only turn the laser
beam on when the workpiece is on the mitre
saw table.
1) Mark the line of the cut on the workpiece.
2) Adjust the angle of mitre and bevel of the cut
as required.
3) Switch on the laser light on/off switch (2).
4) Clamp the workpiece in position using the
laser lines to align the blade with the pencil
mark on the workpiece.
NOTE. To cut to the left side of the blade, align
the left-hand laser line with the pencil mark. To
cut to the right side of the blade, align the right-
hand laser line with the pencil mark.
5) Plug in the machine and start the motor.
6) When the blade is at its maximum speed
(approximately 2 seconds), lower the blade
through the workpiece.
7) After completing the cut, switch off the laser
EN
light on/off switch (2).
8) After each use, clean the laser light assembly
(1) as described below:
remove the plug from the power point.
32
use a soft brush to dust away the sawdust
build-up around the assembly.
NOTE. Wear eye protection while brushing the
dust away.
Maintenance
1) Store the tool, instruction manual and acces-
sories in a secure place. In this way you will
always have all the information and parts on
hand.
2) Keep the tool's air vents unclogged and clean
at all times.
3) Remove dust and dirt regularly. Cleaning is
best done with compressed air or a rag.
4) Never use caustic agents to clean plastic parts.
5) Lubricate the guide roller from time to time
with a drop of oil. It will extend the life of the
roller.
CAUTION. Do not use cleaning agents to clean
the plastic parts of the tool. A mild detergent
on a damp cloth is recommended. Water must
never come into contact with the tool.

General inspection

Regularly check that all the fixing screws are
tight. They may vibrate loose over time.