Location Requirements - Dacor DTF36FCS Manuel D'utilisation

Location Requirements

The following conditions are required when installing your
Distinctive refrigerator.
„ Product must NOT be plugged in during installation.
Otherwise, there is the risk of death or serious injury!
„ Dacor will NOT be held liable for damages that may
arise from procedures carried out by unauthorized
persons.
„ Make sure that the power cord is not pinched or
crushed while pushing the product into place after
installation or cleaning procedures.
„ Choose a location where the refrigerator can be easily
accessed and its doors easily opened.
„ Install the refrigerator at least 12" (30 cm) away from
heat sources such as ranges, cooktops, ovens, and
heaters.
Placement
„ Do NOT place the refrigerator in rooms where the
temperature falls below 50°F (10ºC).
„ Do NOT place the refrigerator in direct sunlight or allow
it to be exposed to humid or other harsh temperatures.
„ Do NOT place the refrigerator on top of rugs or carpets.
„ Place the refrigerator on a flat, level floor surface.
„ Stabilize the refrigerator on uneven surfaces.
Turn the front feet to balance the product. To lower, turn
in the direction of the arrow, to raise turn in the opposite
direction (see image at right, Legs That Stabilize on
Uneven Surfaces).
Air Clearance
„ Provide minimum required air ventilation:
1/2" (1.3 cm) on each side
1/2" (1.3 cm) above the top
1" (2.5 cm) behind the rear
1/2" (5 cm) between two units
„ Attach spacers on the vent cover located on the back of
the refrigerator.
Spacers will create about a 1-inch buffer between the
refrigerator and the rear wall, preventing the refrigerator
from butting against the back wall and stopping air
circulation.
Water Line
Install a water valve on the main water supply pipe.
The refrigerator will connect to this water line.
Water is used for the:
„ Ice maker to produce ice cubes, and for the
„ Water dispenser to provide water for the filtered water
dispensing system.
Location Requirements
Make sure all requirements are followed, and that the
installation is performed according to all codes and
professional standards.
Correct installation is the responsibility of the homeowner.
t i
est anD nspect the
Damaged products cause safety risks and hazards..
Failed products should not be used unless repaired by
an Authorized Service Agent. There is a risk of electric
shock.
Legs that Stabilize on Uneven Surfaces
Spacer on the Back of Refrigerator
main water supply
Main Water Line with Valve
6
IMPORTANT
IMPORTANT
R B i
efRigeRatoR efoRe nstallation
water
valve