Hettich AvanFit YOU 300 Instructions De Service Et De Montage page 24

7. Operation
en
• To change bottom panel thickness from 16mm to 8mm,
release the spacer plates from the retainer and fit into the
upper slot in the aluminium profile.
• Support for rear panel WITHOUT decorative profile
• Support for rear panel WITH decorative profile
(Supports are changed from left to right and vice versa!!!!)
24
Note
A suitable tool (e.g. Allen key) is needed for
i
changing the spacer plates or the supports
for the rear panel. Tool is not included in the
assembly jig.
After securing the staples, remove the drawer from the assembly
jig.