Product Description; Preliminary Checks - King gates MINIMODUS Instructions Et Avertissements Pour L'installation Et L'utilisation

2.

Product description

This product is to be used to automate hinged gates or doors, for
both residential and industrial use.
m
WARNING!
Any other use other than that described and in
environmental conditions other than those listed in this
manual is to be considered improper and prohibited!
The product is an electromechanical gear motor, equipped with a
24 V direct current motor powered by the internal control unit and
a gearbox with an articulated arm.
In the event of a power failure (black-out), it is possible to move
the leaves of the gate by hand by manually unlocking the gear
motor.
3. Installation
m
WARNING! - The installation of MODUS must be carried
out by qualified personnel, in compliance with current regulations,
standards and laws, and following these instructions.
3.1

- Preliminary checks

Before installation, always check that there are no broken product
components, that the model selected is appropriate for the
intended use and that the installation environment is suitable for
the product.
m
IMPORTANT – The gear motor cannot automate
a manual gate that does not have an efficient and safe
mechanical structure.
It cannot correct defects due to bad installation or poor
maintenance of the gate.
3.2 - Suitability of the gate and
installation environment
• Check that the mechanical structure of the gate is suitable for
the installation of an automation system and in compliance
with current local regulations (if necessary, check the data
found on the label of the gate).
• Manually close and open the gate leaf, to make sure that there
is an appropriate level of constant friction during the whole
opening or closing movement (no points requiring increased
effort).
• Check that when moved to any position between fully open
and fully closed, the gate leaf keeps its balance, without
movements.
• Make sure that around the gear motor there is enough room to
easily and safely release the gate leaves by hands.
• Make sure that the product is installed on a solid surface, so
that it can be securely fastened.
• Make sure that the installation position is compatible with the
overall size of the product.
12
FIG.1
The correct opening movement of the gate and the force that the
motor exerts to execute it, depend on the position in which the
motor and arm brackets are fixed. Therefore, before proceeding
with the installation you must check charts 1 and 2 and figure 3
to define the maximum opening angle of the leaf, the limits of the
leaf and the position of the fixing brackets.