Initial Use; Choosing An Installation Site; Preparing The Product; Configuring Default Settings - SilverCrest SMWC 700 B3 Instructions D'utilisation Et Consignes De Sécurité

Initial use

Remove all packaging materials as well as protective
films and check that all parts are complete and un-
damaged. Never remove the light beige Mica cover
in the cooking chamber of the product. This is
1
not a packaging material - its purpose is to protect
the magnetron. If the product is incomplete or dam-
aged upon delivery, please contact the manufacturer.

Choosing an installation site

Choose a level surface which ensures sufficient
free space for the aeration and ventilation of the
product (see Fig. C).
Make sure that the mains plug is easily accessible
so that it can be easily reached and unplugged
in case of danger.
Install the product as far away from radios and
televisions as possible. Operating the product can
cause disruptions in radio or television reception.

Preparing the product

Open the door
9
handle .
8
Before first use, clean the product's cooking
chamber with a cloth and some lukewarm water.
Make sure that no residue is left when removing
all protective and adhesive films.
Place the turntable shaft
base of the cooking chamber. Make sure to in-
sert the turntable shaft
as it will go.
Place the turntable ring
the cooking chamber.
the product without a properly
inserted glass plate
Place the glass plate
and the turntable shaft
glass points on the underside of the glass plate
must engage in the grooves on the turntable
4
shaft .
6
28 GB/IE
by pulling on the door
in the hole in the
6
into the hole as far
6
into the well inside
5
Do not operate
.
4
on the turntable ring
4
. In doing so, the three
6
Close the door
that the door locking mechanism
place.
Plug the mains plug into a professionally in-
stalled mains socket. Make sure that the mains
voltage corresponds to that of the product
(see "Technical data").

Configuring default settings

Setting the time
When the product is operated for the first time or if
the electricity supply is interrupted, the display
shows "0:00" and the time (24-hour display) must
be set.
Press the timer / clock button
The hour display will start to flash.
Turn the rotary control
Then press the timer / clock button
Turn the rotary control
minutes.
Then press the timer / clock button
The time is now set.
Setting the child safety lock
You can activate a child safety lock by pressing
and holding the stop button
3 seconds. A signal tone sounds and
appears in the display
now have no function. After approx. 3 seconds,
the time is displayed again, provided that it has
been set.
You can deactivate the child safety lock by
pressing and holding the stop button
again for 3 seconds. A signal tone sounds and
all functions are available again.

Use

5
the product when empty!
Open the door
handle .
8
by pushing it shut. Make sure
9
clicks into
7
twice.
11
to set the desired hour.
13
11
to set the desired
13
11
for approx.
14
. The product's buttons
2
Never operate
by pulling on the door
9
2
again.
again.
14