Yamaha R-N803 Mode D'emploi page 64

Troubleshooting
Problem
The DAB radio
reception strength is
poor, and noise
(such as hiss,
crackle and jitter)
can be heard.
The DAB information
cannot be displayed
or is inaccurate.
■
Bluetooth
Problem
The unit cannot
connect to a
Bluetooth device.
No sound can be
heard, or the sound
cuts off
intermittently.
58
En
Possible cause
The DAB radio signal is weak.
The DAB station may be temporarily out
of service, or the DAB station
information is not provided by the DAB
broadcaster.
Possible cause
The Bluetooth function is disabled.
The unit is connected to a different
Bluetooth device.
The unit is too far from the Bluetooth
device.
A device emitting electromagnetic waves
(such as a microwave oven and a
wireless device) may be located nearby.
The Bluetooth device does not support
the A2DP protocol.
The connection profile registered in the
Bluetooth device may not be functioning
correctly for some reason.
The passkey on the Bluetooth adapter or
other device may be set to a code besides
"0000".
The volume on the Bluetooth device is
too low.
The sound output on the Bluetooth
device may not be set to this unit.
The connection to the Bluetooth device is
cut off.
The unit is too far from the Bluetooth
device.
A device emitting electromagnetic waves
(such as a microwave oven and a
wireless device) may be located nearby.
Remedy
Change the antenna height, direction, or place of
installation.
Contact the DAB broadcaster.
Remedy
In the "Setup" menu, set "Bluetooth (On/Off)" to
"On".
Disconnect the current Bluetooth connection and
connect with the desired Bluetooth device.
Move the Bluetooth device closer to this unit.
Do not use this unit near devices that emit
electromagnetic waves.
Use a Bluetooth device that supports the A2DP
protocol.
Delete the connection profile in the Bluetooth
device, and then connect the Bluetooth device to this
unit.
Use a Bluetooth device on which the passkey is set
to "0000".
Raise the volume on the Bluetooth device.
Select this unit as the output destination on the
Bluetooth device.
Reconnect with the Bluetooth device.
Move the Bluetooth device closer to this unit.
Do not use this unit near devices that emit
electromagnetic waves.
See
page
13
―
See
page
50
33
―
―
62
32
―
―
32
32
―
―