Installation Instructions; Unpacking And Removing Shipping Bolts; Connecting The Water Lines - Kenmore 592-49032 Manuel D'utilisation Et D'entretien

UNPACKING AND REMOVING
SHIPPING BOLTS
Before you install the washer, make sure the location:
• Has a hard, level surface without carpeting or flooring that may
obstruct ventilation.
• Has no dust, oil and detergent etc.
• Is away from direct sunlight.
• Has adequate ventilation.
• Will not be freezing (below 32 ˚F or 0 ˚C).
• Is away from heat sources such as oil or gas.
• Has enough space so that the washer doesn't stand on its
power cord.
Before using your Washer, you must remove the four shipping
bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with the
spacer through the hole in the rear wall of your washer. Repeat
for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
592-49032-02855B-01_EN_v1.indd 8
All manuals and user guides at all-guides.com

INSTALLATION INSTRUCTIONS

8

CONNECTING THE WATER LINES

1. Before connecting the inlet hoses to the water faucets, check to
ensure a rubber washer is inside each coupling on both ends of
the fill hose..
Coupling
2. Thread the inlet hoses to the HOT and COLD faucet connections
on the washer.
On the other end of the hose, check for one rubber washer per
hose and attach each fill hose to the water valve. Make sure the
hose with the Hot printed line is attached to the HOT faucet.
Tighten by hand until snug, then two-thirds of a turn with pliers.
NOTE: For correct water use, connect both HOT and COLD
water valves. If either or both are not connected, an "nF" (no fill)
error can occur.
3. Turn on the HOT and COLD water supply and check all
connections at the water valve and the faucet for leaks.
Cold printed Hot printed
Rubber Washer
2011-07-22 11:42:11