Marshall MINI JUBILEE 2525H Manuel Du Propriétaire page 2

INTRODUCTION
The JCM25/50 Silver Jubilee Series was produced in 1987 to celebrate 25 years of
Marshall Amplification and 50 years of Jim Marshall being in the music business. Inspired
by this acclaimed series the 2525C 1 x 12" combo and the 2525H 'small box' head combine
Silver Jubilee preamp features and styling in a lower power, 'mini' design.
The 20 Watt 2525 Mini Jubilee™ is expertly crafted and is designed, engineered and
constructed to the highest possible standards at the Marshall factory in Bletchley, England.
And just like original Jubilee Series of amplifiers it features: Bass, Middle & Treble tone
stack, Presence, Output Master (footswitch/pull channel), Lead Master and Input Gain
(pull rhythm clip), with an ECC83 (12AX7) & EL34 valve set. The 2525C is loaded with a
12" Celestion G12M–25 Greenback speaker.
This contemporary 'mini' take on the Jubilee Series also features High/Low output
switching (20 Watt to 5 Watt) and independent 4/8/16 Ohm speaker outputs.
We sincerely hope that your Mini Jubilee proves indispensable, and that it provides you
with years of legendary Silver Jubilee tone, whatever your playing situation.
Thank you for choosing Marshall.
ENGLISH
WARNING! IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Before going any further, make sure that
your amplifier is compatible with your
mains electricity supply. If you have any
doubt, please seek help from a qualified
technician – your Marshall dealer can help
you in this respect.
MAINS INPUT & FUSE:
The specific mains input voltage rating that
your amplifier has been manufactured for is
indicated on the rear panel of the amplifier.
Your amplifier is provided with a detachable
mains (power) lead, which should be
connected to the MAINS INPUT socket on
the rear panel of the amplifier.
The correct value and type of mains fuse is
specified on the rear panel of the amplifier.
- The Marshall Team
NEVER attempt to bypass the fuse or fit one
of the incorrect value or type.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your amplifier is
switched off, unplugged from the mains
electricity supply and all removable
cables have been disconnected from your
equipment before attempting to move it.
IMPORTANT SET UP INFORMATION:
1. When using the 2525H or the 2525C
with an extension speaker cabinet(s),
make sure that the speaker cabinet(s) is
connected to the correct impedance
Loudspeaker jack socket(s) on the rear
panel of the amplifier. See the
LOUDSPEAKERS guide in this manual
for specific information regarding
impedance matching (Rear Panel
Function #17).
WARNING: Failure to do the above may
damage your amplifier. When connecting
a speaker cabinet make sure that you use
a proper speaker cable. Never use a
screened (shielded) guitar cable for this
purpose.
2. Ensure that the POWER switch is set to
the off position (Front Panel Function
#11).
3. Connect the supplied mains (power) lead
into the MAINS INPUT on the rear panel
first and then into an electricity outlet.
4. Ensure that the VOLUME controls on
the front panel are set to zero.
5. Plug your guitar into the INPUT jack
socket on the front panel
6. Ensure that the OUTPUT switch is in the
STANDBY position.
7. Turn the front panel POWER switch on
and wait a couple of minutes before
going to point 8.
8. Engage the amplifier by selecting HIGH
or LOW power (Front Panel Function
#10).
9. Turn the volume up to your preferred
level and your amplifier is ready to play.
ENGLISH