Husky 32220 Instructions D'installation page 9

11. Install cross member and ensure it is centered and straight by shimming (if necessary) and then
torque bolts to 75 lbs.-ft. Note: The roller housing assemblies need to be parallel within 1/4" . Multiple
shims or 1/2" washers can be stacked together if gap width is large. See Figure 11.
Shim location .
A portion of the roller assembly
was removed for clarity.
12. Tighten all 1/4" nuts and bolts to 7 ft.-lbs. The tubes on the handle #7 and connector tube #4 should
crush onto both tube assemblies. This will insure a tight fit. The handle and short/long tube assemblies
should and all move and rotate as 1.
13. Pull handle out and rotate so that both latching pins rotate and lock into hole # 3. See Figure 4. Push
the Husky Roller rearward until the latching pins insert completely into hole #4. See Figure 4. The
Husky Roller should easily move front and back in the truck. See Figure 12.
Maneuvering
Position
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. See
for Warranty Information / Tech Support ©2014 Husky Towing Products Revision: June 03, 2014-REV 4
Towing
Position
Page 9 of 42
Shim location.
Figure 11
Figure 12
Rear of Truck
www.huskytow.com