Husky 32220 Instructions D'installation page 2

Truck Cab and 5th Wheel Trailer Clearance
NOTE! Not all 5th wheel trailers are the same, it is the driver's responsibility to determine what
kind of trailer to cab clearance will result at hook-up time. This can be determined by measuring
the distance from the center of the 5th wheel hitch opening to the rear of the truck cab ("X"
DISTANCE) and adding 4 inches to it. Then measure the width of the trailer and divide this in
half, this will result in the ("Y" DISTANCE). The "X" DISTANCE must be equal to or greater than
the "Y" DISTANCE. This does not mean that your 5th wheel trailer cannot still come in contact
with the truck cab. Always have a spotter to help be your eyes to warn you when to stop turning.
Husky Fastener Torque Specification
All "Husky Roller" fasteners are grade 5
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. See
for Warranty Information / Tech Support ©2014 Husky Towing Products Revision: June 03, 2014-REV 4
TOOLS REQUIRED:
3/16" ALLEN WRENCH
7/16" WRENCH & SOCKET
9/16 WRENCH & SOCKET
3/4" WRENCH & SOCKET
TORQUE WRENCH (150 LBS.-FT. MIN.)
*These tools only required if you do not have
a center bolt kit installed in your base rails.
Page 2 of 42
DRILL*
5/8" DRILL BIT*
www.huskytow.com