Husky 32220 Instructions D'installation page 7

Figure 6
REAR OF
TRUCK
#4
4. Slide the connector tube #4 onto the short tube assembly #3 so that it compresses the compression
spring #6. See Figure 6.
5. Align the 1/4" hole attachment holes line up in the connector tube #4 and the short tube assembly #3.
Loosely assemble connector tube #4 and the short tube assembly #3 with the 1/4" bolt #9 & 1/4" nut #8.
See Figure 6.
6. Determine which foot print of Husky Roller you need. Refer to your original 5th wheel instructions. See
Figure 1 for assistance. If your 5th wheel requires a 20-5/8" stance proceed to Step 7a. If your 5th
wheel requires a 29" stance proceed to Step 7b. If your 5th wheel requires something different do NOT
use this roller and contact your 5th wheel manufacturer for assistance
7a. Loosely assemble connector tube #4 and the long tube assembly #2 with the 1/4" bolt #9 & 1/4" nut
#8; use hole #5. See Figure 7.
7b. Loosely assemble connector tube #4 and the long tube assembly #2 with the 1/4" bolt #9 & 1/4" nut
#8; use hole #6. See Figure 7.
8. Place the roller housing assembly onto the driver side of the installed base rails and pin in place with
the base rail pins and hair pins supplied with base rail kit. See Figure 1 for correct slot use. See Figure
8 for base rail pin orientation. The base rail pin MUST point AWAY from ALL the anti-lift screws on
both roller assemblies.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. See
for Warranty Information / Tech Support ©2014 Husky Towing Products Revision: June 03, 2014-REV 4
#9
#8
Hole #5
Figure 7
Page 7 of 42
#3
#2
Hole #6
www.huskytow.com