Fujitsu DYNAMO 640 AI Guide D'utilisation page 38

The power indicator does not light up.
· Is the power cable properly connected?
The computer does not recognize the 640AI.
· Is the Busy indicator on?
· Is the IDE cable connected properly?
· Is the master/slave selected properly?
· Is the BIOS of 640AI set to "NONE"?
· Have you tried other IDE port?
· Is the device driver installed?
· Is the MO Disk inserted correctly?
· Is the MO Disk formatted correctly?
You cannot insert the MO Disk.
· Is the MO Disk being inserted in the correct direction?
· Is another MO Disk already inserted?
You cannot eject the MO Disk.
· Is the Busy indicator on?
· Is your application software preventing the disk from being ejected?
You cannot record data on the MO Disk.
· Is the device driver installed?
· Is the MO Disk formatted?
· Is the MO Disk write-protected?
Your hard disk drive appears to be working slowly, or the Device Manager of
Windows 9x indicates that the hard disk drive is in MS-DOS compatible
(16bit) mode, after you install the DynaMO 640AI.
· Is the BIOS of 640AI set to Ultra DMA?
· Is the BIOS of 640AI set to other than "NONE"?
· Is DMA configured correctly for DynaMO 640AI in the device manager?
1.32