Party Function - Seltron RCD1 Mode D'emploi

SETTING THE TEMPERATURE FOR FROST PROTECTION
We can change the setting of the desired room temperature which is
considered when the heating is on.
When the heating is off, by pressing the button
the display of the set temperature.
If the button
the setting value will begin to flash. Now you can change it with buttons
and .
By pressing the button we confirm the setting. By the next press of the
button return to the basic display.
For the frost protection to be active, the boiler or the heat
generator must be turned on!
Frost protection temperature setting is enabled only when
heating is off and functions Party, Eco and Vacation are not
active.

PARTY FUNCTION

Party function enables to turn on heating after the desired comfort
temperature at any time.
Function can be activated by pressing the button
Now we can change the desired comfort temperature with buttons
and . Change the setting while the value is flashing. By pressing
the or button, we move to time setting. Use buttons
set time until when comfort heating should operate. Value between the
pulse setting. By the next press of the button
display..
or is pressed and held for at least 2 seconds,
desired comfort or Party temperature
time when Party function expires
Party function display
or recall
(RCD2 only).
and
or return to the basic
English 11
to