Atag VA2113PT Manuel D'utilisation page 64

Table continued from last page
Problem
Spots on stainless steel or sil-
ver.
Spots or films on the dishes.
The dishes have a sticky
white/blue film.
28
Possible causes
Glasses and cups have toppled
over during the program.
The filters are not fitted cor-
rectly.
Drainage pump stop missing.
Some foodstuffs, such as mus-
tard, mayonnaise, lemon, vineg-
ar, salt and dressings, can
cause spots on stainless steel
if left for too long.
All stainless steel can cause
spots on silver if they come into
contact during dishwashing.
Aluminium can also cause spots
on dishes.
The water softener is leaking
salt.
Incorrect water softener setting.
Incorrect rinse aid dosage set-
ting.
Salt compartment empty.
3-in-1/ All-in-one detergent is
used and the setting TAB (3-in-
1/ All-in-one detergent) is activ-
ated.
Too high temperature and/or
too much detergent can cause
etching on crystal. Unfortu-
nately, this cannot be repaired,
only prevented.
Rinse aid dosage setting too
high.
Action
Place dishes to sit steady.
Check that the filter handle is
locked in the stop position. The
handle should point straight out
from the dishwasher.
Check that the coloured stop
on the right in the bottom drain
is in place. See the chapter Care
and cleaning.
Rinse off these types of food-
stuffs if not starting the dish-
washer immediately. Consider
using the One hour program
program with the SpeedWash
option.
In order to avoid marks and tar-
nishing, separate dishes made
from different metals, such as
silver, stainless steel and alu-
minium.
Check that the salt compart-
ment lid is properly tightened.
Otherwise call the service de-
partment.
See the chapter Settings.
See the chapter Settings.
Top up with salt. See the
chapter Before washing for the
first time.
Inactivate the setting TAB (3-in-
1/ All-in-one detergent) and top
up salt and rinse aid.
Wash crystal at a low temperat-
ure and with a conservative
amount of detergent. Contact
the detergent manufacturer.
Reduce the amount. See the
sections Before washing for the
first time and Settings. If you
have very soft water, you may
want to dilute the rinse aid
50:50 with water.