Starting Your Refrigerator; Refrigerator Operation; Alarms; Door Ajar - Viking Range 5 Serie Manuel D'installation, D'utilisation Et D'entretien

Alarm
Figure 12
close-up of
control
Set
Press and Hold

Starting your refrigerator

Plug the refrigerator power cord into a wall outlet. Your
refrigerator will begin cooling after power is applied.
If your refrigerator does not start, check that the refrigerator
is turned on and the set temperature is cold enough.
Turning your refrigerator ON or OFF
If the refrigerator is on, the refrigerator temperature will be
shown on the display. To turn the refrigerator off, press and
hold the "ON/OFF" button for three (3) seconds. "OFF" will
appear on the display.
If the refrigerator is not on, "OFF" will be shown on the
display. To turn the refrigerator on, press and hold the
"ON/OFF" button for three (3) seconds. The refrigerator
temperature will be shown on the display.
Set temperature
To set the refrigerator temperature, press and hold the
"SET" button. When the "SET" button is pressed, the
display will show the set temperature. While holding the
"SET" button, press the "WARMER" or "COLDER" buttons
to adjust set temperature.

Refrigerator operation

The available temperature range of the refrigerator is 34° to
42°F (1° to 6° C).
It may take up to 24 hours for your refrigerator to reach
desired temperature. This will depend on amount of content
loaded and number of door opening and closings.
For best results allow refrigerator to "pull down" to desired
set temperature before loading. Once contents are loaded,
allow at least 48 hours for temperature to stabilize before
making any adjustments to the set temperature.

Alarms

Your electronic control will monitor refrigerator function and
alert you with a series of audible and visual alarms.
• Door Ajar Alarm: If the door has been left
open for over fi ve (5) minutes, the alarm
will sound in one (1) second intervals. The
display panel will fl ash "do" and the Alarm LED located at
the top left of the display below the word "Alarm" will be
illuminated. This will stop as soon as the door is closed.

USING YOUR ELECTRONIC CONTROL

F
Colder Warmer
ON/OFF
Press and Hold
• Temperature Sensor Fault: If the control-
ler detects that the temperature sensor is
not properly functioning, a temperature
sensor alarm will sound in one (1) second intervals. "E1"
will fl ash on the display panel and the Alarm LED located
at the top left of the display below the word "Alarm" will
be illuminated. Please call Viking Range,LLC Customer
Service or your dealer if this error code is displayed.
• High and Low Temperature Alarm: If the
storage compartment temperature deviates
excessively from the set-point temperature,
the alarm will sound in (1) second intervals.
The display panel will fl ash either "Hi" or "Lo"
depending upon the condition and the Alarm
LED light at the top left of the display below
the word "Alarm" will be illuminated. The alarm will remain
active until the condition is corrected.
NOTE
After a high temperature alarm condition, check all
perishables to ensure they are safe for consumption.
NOTE
The temperature alarm may occur as a result of high
usage or introduction of warm contents to the storage
compartment. If the temperature alarm continues to occur,
your unit may require service.
10
Figure 13