Technical Informations; Installation - Hendi 975336 Mode D'emploi

1.5. TECHNICAL INFORMATIONS

Do not remove the "CE MARKING" plate and/or re-
place it with a different one. Should the CE MARK-
ING plate be accidentally damaged, detached from
Do not remove the CE MARKING plate and/or re-
place it with a different one. Should the CE MARK-
ING plate be accidentally damaged, detached from
External vacuum packaging machine
Pakowarka próżniowa – listwowa
Item
Kod
Weight
Waga
Date
Data

2. INSTALLATION

Remove the package and check that machine is undamaged. In particular, look for possible damages caused
by transport. If in doubt, do not use the machine and refer to the producer.
2.1. PLACE
Position the machine in a place with low humidity percentage and far from heat sources.
DO NOT INSTALL THE MACHINE IN AN EXPLOSIVE ATMOSPHERE
2.2. CONNECTIONS
Before connecting the vacuum packing machine,
make sure that plate correspond with supply mains
data.
The plate is located on the casing side.
After level checking and casing re-installation, con-
nect the plug to a current outlet of 220V.
Steenoven 21, 3911 TX Rhenen
The Netherlands, www.hendi.eu
Power
975336 250 W
Moc
Voltage
8 kg 230 V
Napięcie
Serial no.
Nr seryjny
the machine or the manufacturer's seal removed,
the client must compulsorily and immediately in-
form The Producer.
the machine or the manufacturer's seal removed,
the client must compulsorily and immediately in-
form The Producer.
370x260
x(H)130 mm
DISCONNECT THE POWER SUPPLY PLUG FROM
THE MAINS BEFORE STARTING ANY CHECKING
OPERATION WHITCH MAY REQUIRE PARTS DISAS-
SEMBLY.
EN
5