Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. The supply can feed either into the side of the burner base, or is fed from below the base. The gas
line needs to be disconnected from the gas valve and reconnected in order to do this. This must be
done by a licensed gas fitter and the connections need to be leak tested according to the leak testing
instructions before using the unit.
The gas supply is shown entering
the bottom of the burner.
4. The burner unit can be built into a non-combustible enclosure. The control module can be removed
from the burner unit and located up to 12" away from the burner unit. A cap is provided to close the
opening in the side of the burner module. The gas line needs to be disconnected and reconnected in
order to do this. This must be done by a licensed gas fitter and the connections need to be leak tested
according to the leak testing instructions before using the unit.
Removing Control Panel
4 x N570-0013
The gas supply is shown entering
the side of the burner.
7
EN
www.napoleongrills.com
Publicité
Table des Matières
