Cycling (Charging / Discharging) Nickel Batteries; The Nixx Cycle Menu - Multiplex MULTIcharger LN-6015 EQU Instructions

11.3. Cycling (charging / discharging) Nickel batteries

The final discharge voltage for the discharge process during cycling (charging and discharging) is
set in the NiXX DISCHARGE menu; the charger automatically accepts this setting in the NiXX
CYCLE menu. The method of setting the final discharge voltage is described earlier in Chapter
11.2.
NiMH CYCLE D->C 1
C=0.1A
DEC
ENTER
DEC
NiMH CYCLE D->C 1
C=0.1A
ENTER
DEC
NiMH CYCLE C->D 1
C=0.1A
ENTER
DEC
NiMH CYCLE C->D 5
C=1.0A
ENTER
DEC
NiMH CYCLE C->D 5
C=1.0A
START
BATTERY CHECK
WAIT PLEASE...
C->D 0:00
NM+1.00A
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten • www.multiplex-rc.de
MULTIcharger LN-6015 EQU Operating Instructions
Pressing the DEC button takes you to the NiMH DISCHARGE
D=0.10A menu.
INC
Press the ENTER button to set whether you wish to start with
discharging and end with charging (
charging and end with discharging (
D=0.10A
DEC button to switch to and fro between the modes.
INC
Press the ENTER button again to adjust the number of cycles.
You can increase this value by pressing the INC button, or
reduce it by pressing the DEC button.
D=0.10A
INC
Pressing the ENTER button again takes you to setting the
charge current. You can increase this value by pressing the INC
button, or reduce it by pressing the DEC button.
D=0.10A
INC
Pressing the ENTER button again takes you to setting the
discharge current. You can increase this value by pressing
the INC button, or reduce it by pressing the DEC button.
D=1.00A
Hold the START button pressed in to initiate CYCLE mode.
You can interrupt the CYCLE process at any time by pressing
the STOP button.
The MULTIcharger LN-6015 EQU now checks whether the
00000
battery is correctly connected. If all is well, it initiates the
7.915V
charge / discharge cycle you have selected.

the NiXX CYCLE menu

D->C), or start with
C->D). Press the INC or
Page 17/24