Charging Lithium Batteries; The Lixx Charge Menu - Multiplex MULTIcharger LN-6015 EQU Instructions

10.1. Charging Lithium batteries

The MULTIcharger LN-6015 EQU equalizes your Lithium batteries during charge and discharge
processes, provided that you have connected your battery's balancer socket to the EQUALIZER
port before starting the charge / discharge process. If you do not make this connection before
initiating a charge / discharge process, no equalizing will take place during charging / discharging.
If you disconnect the balancer socket of your Lithium battery from the EQUALIZER port of the
MULTIcharger LN-6015 EQU during the charge / discharge / equalize process, the charge pro-
cess will be interrupted, and the screen will display an error message.
The set-up process for charging, equalizing and discharging Lithium batteries is explained in the
following section, based on a LiPo battery. The procedure is the same for LiFe and LiIo batteries.
MPX-MULTIcharger
LN-6015 EQU V1.0
LiPo CHARGE
C= 100mAh 7.4Vp
ENTER
DEC
LiPo CHARGE
C= 3200mAh 7.4Vp
ENTER
DEC
LiPo CHARGE
C=3200mAh 11.1Vp
START
BALANCER CON.
NOT CONNECTED
BATTERY CHECK
WAIT PLEASE...
CHG 0:00 00000
LP+3.20A 11.465V
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten • www.multiplex-rc.de
MULTIcharger LN-6015 EQU Operating Instructions

the LiXX CHARGE menu

When you connect the charger to a mains PSU or a car battery,
the MULTIcharger LN-6015 EQU greets you as shown here.
INC After the greets, the display shown on the left side appears. Press
the button INC to move to the LiPo EQUALIZE menu.
Press the ENTER button to move to setting the Capacity charge parameter.
INC
When the value is flashing, you can increase the value by pressing the INC
button, or reduce it by pressing the DEC button.
INC Press the ENTER button again to set the nominal voltage of your Lithium
battery. Press the INC button to increase this value, or the DEC button to
reduce it.
BALANCER CON.
CONNECTED
BATTERY CHECK
WAIT PLEASE...
CHG 0:00 00000
LP+3.20A 11.465V
EQU 0:00 00000
LP+3.20A 11.465V
Hold the START button pressed in to
initiate the charge process. Press the
STOP button at any time to interrupt the
charge process.
The MULTIcharger LN-6015 EQU now
checks whether you have connected the
balancer socket of your Lithium battery to
the EQUALIZER port, and whether all the
charge parameters have been set correctly.
After this the charger initiates the charge
process, and simultaneously equalizes
your Lithium battery – provided that your
battery's balancer socket is connected to
the EQUALIZER Port (right display). If not,
it will charge your Lithium battery without
matching the individual cell voltages.
Page 12/24