Makita 3706 Manuel D'instruction page 6

When the cut is complete, turn the tool off and wait for
the bit to stop rotating and then carefully remove it from
the material.
NOTE:
1. When using this tool, the rotating action causes the
tool to pull. The less pressure applied to the tool
causes less pull and provides a more accurate cut.
Excessive pressure or fast cutting can cause the bit
to dull or break premature.
2. When cutting drywall around outlet boxes, cut in a
counterclockwise direction for ease of cut.
3. The standard bit included with this tool is for cutting
drywall only. When cutting materials other than dry-
wall, do not use the standard drywall guide bit.
Circular guide
Circular cutting diameters: 10 cm (4") - 34 cm (13-3/8")
Installing circular guide
2 3
1
Release the thumb screw which serves to secure the
shoe.
Align the projections in the circular guide with the
grooves in the shoe, and secure the shoe and circular
guide using the thumb screw.
2
3
1
To adjust the cutting depth, proceed first by loosening the
thumb screw and then by sliding the shoe and circular
001630
004973
1. Shoe
4
2. Loosen
3. Tighten
4. Thumb screw
004974
1. Shoe
2. Circular guide
3. Projections
guide together. After completion of the adjustment,
tighten the thumb screw securely.
1
OPERATION
3
2
Loosen the knob, and adjust its position in accordance
with the size of the circle to be cut. (The hole dimensions
to be cut are indicated on the side of the circular guide as
a general guideline.) After completion of the adjustment,
tighten the knob securely.
Insert the end of the knob into the center of the circle to
be cut, and proceed to cut in a clockwise direction.
1
Vacuum cover
Cleaner operations can be performed by connecting the
cutout tool to Makita vacuum cleaner or dust collector.
Installing vacuum cover
2
6
001633
1. Shoe
2
2. Circular guide
3
3. Thumb screw
001634
1. Knob
2. Tighten
1
3. Loosen
001635
1. Knob
001636
1. Thumb screw
1
2. Vacuum cover