Philips SmartSleep Snoring Relief Band Mode D'emploi page 18

20
Switching off the adaptation phase
The sensor shows a small dot on the left side
of the display to indicate that the adaptation
phase is active.
You can manually switch off the adaptation
phase. Press and hold the activation button for
five seconds when the sensor shows one of
the data screens. The sensor vibrates after two
seconds, but keep the button pressed until the
sensor has counted down from three to one
and you feel another vibration. The final
vibration indicates that switching off the
adaptation phase was successful.
2 sec.
The data of your last sleep session has been
removed and the display shows '- -'.
5 sec.
3 sec.