Clamping And Releasing Workpieces; Clamping The Workpiece - Allmatic TeleCentric Instructions De Service

ALLMATIC
9.3

Clamping and Releasing Workpieces

Clamping the workpiece

1. Move the jaws to the workpiece by turning the spindle clockwise.
ð As soon as the force is built up, the resistance increases greatly.
2. Continue turning until the torque spanner displays the maximum clamping force by clicking.
ð Clamp the workpiece with max. 45 Nm.
For clamping force curve, see Technical Specifications [} 49].
Unclamping the workpiece
NOTICE
Continued turning of the spindle after the end stop is reached.
Damage to the TeleCentric.
Ø Do not continue to turn the spindle after the end stop is reached.
TeleCentric
Operation | 9
EN
67 / 400