Description - Allmatic TeleCentric Instructions De Service

ALLMATIC
6

Description

2
6
5
Fig. 7: Product description
1 Inner spindle
2 Spindle nut
3 Outer spindle for socket spanner insert
WAF 14
When the outer spindle (3) is turned clockwise with a torque spanner, the inner and outer
spindles (1, 3) move into each other and the spindle nuts (2) move in the direction of clamping.
The spindles (1, 3) remain flush with the spindle nuts (2). The TeleCentric can be fixed to the
machine table via the screw plugs (4) and the boreholes on the lower section (5). The zero point
can be finely adjusted on the middle column (6).
Avoid excessive torque.
Damage to the TeleCentric.
Ø Set the torque spanner used to max. 45 Nm (30 kN clamping force).
TeleCentric
4 Screw plug
5 Lower section
6 Centre column
Description | 6
EN
1
2
3
4
53 / 400