6.
INSTRUMENT PANEL
6.1 Introduction
The Thermostatic Control Panel must be used as intended by FERROLI which is not responsible for any damage caused to people, animals
or property due to incorrect installation, adjustment, maintenance and improper use.
ATTENZIONE
•
The Thermostatic Control Panelmust be installed by qualified personnel or by a FERROLI Authorized Technical Service in
compliance with the Technical Standards and current national and local regulations.
•
Also the safety, installation, maintenance and operating instructions given in this manual must be followed.
DIVIETO
• The use and maintenance of this unit by unsupervised disabled persons and children IS PROHIBITED.
6.2 Description of panel
The Thermostatic Control Panel is a boiler thermal controller, equipped with:
• Boiler feed switch;
• Burner ignition switch;
• Circulating pump activation switch;
• Safety thermostat test button (chimney sweep function);
• Safety thermostat reset button;
• Digital thermometer with indication of delivery temperature;
• LED lamps for indicating operation status;
• Manual reset safety thermostat (110°C);
• Adjustable working thermostats (burner 1st and 2nd flame).
There are also thermostat capillaries, a probe for measuring the boiler temperature, and a prewired power supply cable.
For the generation of heat, this panel can manage hot water boilers equipped with single-stage, two-stage and modulating burners (the
latter with burner modulation regulator).
6.3 Compliance
The Thermostatic Control Panel complies with:
• Low Voltage Directive 2014/35/EU
• Electromagnetic Compatibility Directive 2014/30/EU
• Directive 2011/65/EU (RoHS 2, restriction on hazardous substances)
6.4 Dati tecnici
Electrical power supply
Load control outputs
Electrical protection rating
Fuse
Boiler safety thermostat
Maximum absorption
78
EN
220V÷240V - 50/60 Hz
230V - 3A
IP 20
F 6,3A L 250V
110 (0/-6)°C
6,3A
cod. - Rev. 02 - 03/2018
TP3 COND