Armytek WIZARD C2 PRO Manuel D'utilisateur page 3

Set description
Flashlight, 18650 Li-Ion battery, magnetic USB charger, clip, head-
mount, bicycle mount ABM-01, 2 spare O-rings, user manual.
The flashlight and accessories can inconsiderably differ from the
pictures in the manual. The producer reserves the right to change
the package at his own discretion without modifying this manual.
Specifications are subject to change without notice.
Initial Service
TO SET/REPLACE BATTERY
1. Unscrew the tailcap.
2. Place the battery with the positive contact (+) facing the head of the
flashlight.
3. Adjust the tailcap and tighten it as far as it can go.
The flashlight is ready for operation.
HOW TO CONNECT THE MAGNETIC CHARGER
Unscrew the tailcap for 1/4 of a circle and adjust the magnetic charger
to the tailcap.
CHARGER COLOR INDICATION
Charger not plugged in:
• Green — device is in waiting mode.
Charger plugged in:
• Green blinking — evaluation of battery voltage.
• Red blinking — unscrew the tailcap for 1/4 for charging.
REV_00-0001
• Orange blinking — USB power source voltage is too low for correct
continuation of charging or bad contact between charger and battery.
Try cleaning the tailcap and the threads of the flashlight parts or use a
different power source.
• Red — charging is going on, charging current is 1A.
• Orange — USB power source voltage is too low, charging current has
been reduced by half.
• Green — charging is finished.
Operation
Before use: Tighten the tailcap.
GENERAL TYPE
Modes: Firefly1, Firefly2, Main modes, Turbo1, Turbo2 or Turbo3 (last
used in Advanced, Turbo2 by default).
In OFF state
1 click: To turn on the last used mode.
Press and hold: To start cycling through Firefly modes. Release to
select. Keeping button pressed will start cycling through Main modes.
In ON state
1 click: To turn off the flashlight.
Press and hold: To start cycling through Main modes from any mode. In
Firefly1 cycling through Main modes starts after cycling through Firefly
modes. Release to select.
2 clicks: To turn on Turbo mode from any mode. The second double click
brings back last used mode.
ADVANCED TYPE
To switch between types of operation unscrew the tailcap to 1/4 while
the flashlight is off, press the button and tighten the tailcap while
keeping the button pressed.
Sections of modes:
[1] – Firefly modes, [2] – Main modes, [3] – Turbo modes,
[4] – Strobe modes
In OFF state:
1 click: To turn on the last used mode.
Press and hold: To turn on Firefly1 mode [Section 1]. Keeping button
pressed will start cycling through modes: Firefly1 - Firefly2 - Firefly3 -
Main1 - Main2 - Main3 - Turbo1.
WIZARD C2 PRO USER MANUAL ENG 3