Rowenta INTENSE PURE AIR CONNECT PU608 Serie Mode D'emploi page 19

Theschedulingdoesn'twork:
If the time slot is earlier than current time, by default the product will start next day.
Whythepairingdidn'twork?
Supported encryption type : WPA_1/WPA_2, TIPK, PSK, AES,
Supported networks: 2.4 GHz (not 5Ghz)
IfthereisaproblemwithmyhomeWi-fiduringmyholidayperiod,Ican't
controlmypurifierviatheappanymore?
If the product lost its connection, the product will stop automatically after 24h.
I can't control my product:
If the Wifi LED on the product is lighted permanently but you can't control it via the APP. Please
unplug the product, wait for 10 seconds and replug the product. The product could be reconnected
automatically.
• Indicationofairquality
Air quality indicator (A) is located on the top of the appliance.
Air Quality
Excellent
Slight pollution
Moderate pollution
High pollution
Extreme pollution
MAINTENANCE
Always switch the appliance off with the button (9) and unplug it before conducting any maintenance operation.
You can clean the appliance with a slightly damp cloth.
IMPORTANT: Never use abrasive products which could damage your appliance's appearance.
FILTERS
Filter
Pre-filter
Active carbon filter
Allergy+ filter
NanoCaptur+ filter
These figures are based on tests in which the air purifier is used for 8 hours per day in quiet mode.
The recommended frequency for cleaning and replacing the filters may vary depending on the
duration of use and the operating environment.
• A light indicates when the allergy+ filter needs to be replaced.
The light display indicates when the carbon filter needs replacing.
• The NanoCaptur+ filter contains translucent granules which change color according to the for-
maldehyde absorption rate. Refer to the color chart on the sticker inside the front door or the
filter itself to establish the filter saturation rate.Once the saturation rate has reached its maxi-
mum, the filter must be replaced. You have to check the filter saturation rate every six months.
• The pre-filter can be re-used: remove the dust using a vacuum cleaner or wash with water.
Air quality indicator color
Blue
Green
Yellow
Orange
Red
Action
Clean
Replace
Replace
Replace
Cycles
Every 2 to 4 weeks
Every 12 months
Every 2 years
Color changing
(see Color chart on filter)
EN
19