Speed Dial; Hard Reset - eTIGER S4 Combo Secual Mode D'emploi

Register Wireless Accessories & RFID Tags
1. Type your admin code followed by "Enter" on the control panel to enter the setup menu.
2. Enter the Connection Mode by navigating through the menu:
"ACCESSORIES" -->
When registering a detector, you will be asked to select the type of detector (Normal Sensor, Home
Sensor, Delay Sensor, 24 Hour Sensor). More information on page 10.
3. Trigger the accessory once within the next 15 seconds (for the RFID tag, swipe it in front of the
RFID reader of the control panel). You hear one beep: the registration is successful.
Default admin code is 123456. To change the admin code, refer to the instructions "Admin Code" on page
11.
If the accessory has already been registered, the control panel will beep twice. The first accessory
registered is assigned to zone 1, the second accessory registered is assigned to zone 2, etc. Zones
1 to 9 can be renamed. Zones 10 to 50 cannot be renamed (refer to the instructions on page 19
to learn how to rename zones).

Speed Dial

Press the Call button " " on the control panel for 3 seconds: the panel auto-dials the first stored
phone number. Press the Call button " " to end the call.
Hands-free Phone Call from the Panel
Through PSTN
Press the Call button" " on the control panel, type the phone number you wish to call and press "Enter" .
Through GSM
Press the Call button" " on the control panel, type the phone number you wish to call and press
the Call button " " again.

Hard Reset

Turn the control panel off. Press and hold the " " key while turning the control panel on. Then
enter "123456" on keyboard.
Settings will be restored to default values. Stored phone numbers and connected accessories
will be cleared.
"WIRELESS SENSORS" , "RFID TAG" or "REMOTE" --> "ADD A NEW"
7