eTIGER S4 Combo Secual Mode D'emploi page 11

Main Menu Sub Menu 1
SYSTEM SETTINGS DATE AND TIME
SYSTEM SETTINGS ENTRy ExIT DELAy
SYSTEM SETTINGS AUTO ARM / DISARM
SYSTEM SETTINGS CONTROL By PHONE
SYSTEM SETTINGS LINECUT ALARM
SYSTEM SETTINGS GSM FAIL TIP
SYSTEM SETTINGS KEyPAD TONES
SYSTEM SETTINGS ACCESS CODE
Sub Menu 2 Sub Menu 3
YYYY-MM-DD TIME
ENTRY DELAY 000-300
ExIT DELAY 000-300
AUTO ARM TIME <00:00>
AUTO DISARM TIME <00:00>
ON OR OFF?
ON / OFF -
ON / OFF -
ON / OFF
ON / OFF -
ADMIN CODE 123456
USER CODE 1234
DURESS CODE 0000
OPEN DOOR CODE 8888
Comments
This function can be used if you do not want to bring a remote
control or RFID tag with you. When the system is armed, you hear
one beep every second to remind you to leave. The beep rhythm
speeds up during the last 10 seconds. If an intruder is detected, the
alarm will be delayed accordingly.
Time is calculated in seconds. The Entry and Exit Delay can be set
from 0 to 300 seconds.
You can set up the system to arm and disarm automatically at a
defined time every day.
You can activate or deactivate the control of your system by phone
call. Activating the control by phone call enables you to arm and
disarm the system and monitor your home by phone call.
If the linecut alarm is on, the alarm will be triggered if your
telephone line is down. The first SMS number stored receives a
notification by SMS (only in GSM mode).
Notification of SIM/ GSM signal problem.
Activate or deactivate the sound when typing on the keyboard of
the control panel.
Your admin code enables you to enter the setup menu.
Default admin code: 123456
Your user code enables you to disarm the system on the control
panel. The user code is the access code requested when you call
the control panel.
Default user code: 1234
In case of emergency, when you are requested to disarm the sys-
tem by force, it is recommended to disarm your system with your
Duress Code. The panel will silently dial the stored phone numbers.
Default duress code: 0000
You can open electronic doors using this code. The door must be
wired to the [LOCK] interface on the back of the control panel.
Note
(e.g. 2014-06-20 14H30)
The entry and exit delay is only for sensors
connected as Delay Zone accessories (see
"Wireless" on page 10).
The Entry Delay gives you time to disarm
the system on the control panel without
triggering an alarm.
The Exit Delay gives you time to arm the
system on the control panel and leave
your home without triggering an alarm.
Setting Auto Arm and Auto Disarm to
the exact same time will deactivate the
function.
See instructions on page 13 for more
information on the control of the system
by phone call.
Deactivate this function if you want
to use the alarm system in GSM mode
only.
Deactivate this function if you want to
use the alarm system in PSTN mode only.
It is recommended to change all codes
before using your system for the first
time and to keep your codes secret
11