Control By Phone Call - eTIGER S4 Combo Secual Mode D'emploi

Control by Phone Call

This feature is available only after having enabled it from the control panel, as explained on page
11 of this manual.
Method 1
When an alarm has been triggered, the control panel dials the stored phone numbers. When
you pick up the phone, follow the voice instructions to control the panel from distance (refer
to the instructions in the table below).
Method 2
1. Dial the telephone number of your control panel (either the number of the SIM card in your
control panel or the number of the landline to which your panel is connected). After getting
through, the voice instructions will guide you to enter your access code.
2. Enter your access code (user code), followed by "#".
3. A voice gives you the options you can select.
4. Select the operations to control the panel (see instructions in the table below).
Note
The call will end automatically if you do not send any command within 30 seconds.
Table of commands for control by phone call
Command Function
Press "1" Arms the system
- Disarms the system and turns the
siren off
Press "0" - Stops monitoring without hanging up
- Ends the phone call without hanging
up
Press " " Audio monitoring
Press "3" Phone call with control panel
Press "6" Turns the siren off
Press "9" Turns the siren on
- Disarms the system and turns the
Press "#" siren off
- Exits control by phone call
Note
In GSM mode, the audio monitoring is not limited in time.
In PSTN mode (connected to your landline), the audio monitoring is limited to 80 seconds. If
you wish to extend the time of audio monitoring, press the " " on your phone before the end
of the 80 seconds.
Comment
Voice prompt "System
Voice prompt "System
Press " " to extend the monitoring time
-
-
-
Hanging up also exits the control by
phone call.
armed"
disarmed"
13