Assembly & Installation; Break-In Procedure - PRO-POINT 8866626 Consignes De Sécurité

V1.0
G Air Pressure Gauge - This
gauge measures the regulated
outlet pressure.
H Air Outlet Quick Connect -
Connect an air hose to this
outlet. Two outlets available.
I Drain Valve
J Power Cord
K OFF/AUTO Switch - This switch
turns on the compressor. When
in the ON position, the
compressor will start up or shut
down automatically, without
warning, based on air demand.
ALWAYS set this switch to OFF
when the compressor is not
being used, and before unplugging the compressor.
L Safety Valve (not shown) - The air compressor is equipped with a
safety-relief valve that is designed to discharge tank pressure at a
predetermined setting. Check the safety valve periodically by
pulling on the ring, but only when the tank pressure is completely
drained. The spring loaded valve should move freely within the
safety valve body. An inoperable safety valve could allow an
excessive amount of tank pressure to build causing the air tank to
catastrophically rupture or explode. Do not tamper with or attempt
to eliminate the safety relief valve.
M Rubber Foot (4)
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
The air compressor is preassembled.

BREAK-IN PROCEDURE

Prior to hooking up accessories, run the compressor continuously for
15 minutes with the drain valve open.
Visit www.princessauto.com for more information
4 Gallon Portable Quiet Air Compressor 8866626
9