General Safety Instructions - Belden HIRSCHMANN OZD Modbus Plus G12 Manuel

We have checked that the contents of the technical
publication agree with the hardware and software des-
cribed. However, it is not possible to rule out devia tions
completely, so we are unable to guarantee complete
agree ment. However, the details in the technical publica-
tion are checked regularly. Any cor rections which prove
necessary are contained in subsequent editions. We are
grateful for suggestions for improvement.
We reserve the right to make technical modifications.
Permission is not given for the circulation or reproduction
of this document, its use or the passing on of its contents
unless granted expressly. Contravention renders the
perpetrator liable for compensation for damages. All
rights reserved, in particular in the case of patent grant
or registration of a utility or design.
© Hirschmann Automation and Control GmbH 2014
All Rights Reserved
Note
We would point out that the content of these operating
instructions is not part of, nor is it intended to amend an
earlier or existing agree ment, permit or legal relation-ship.
All obliga tions on Hirschmann arise from the respective
purchasing agreement which also contains the full war-
ranty conditions which have sole appli cability. These
contractual warranty conditions are neither extended nor
restricted by com ments in these operating instructions.
We would furthermore point out that for reasons of
simplicity, these operating instructions cannot describe
every conceivable problem associated with the use of
this equipment. Should you require further information or
should particular problems occur which are not treated in
sufficient detail in the operating instructions, you can
request the necessary information from your local Hirsch -
mann sales partner or directly from the Hirschmann
office (address: refer to chapter entitled "Notes on CE
identification").
Safety Instructions
This manual contains instructions which must be observed
to ensure your own personal safety and to avoid damage
to devices and machinery. The instructions are high -
lighted with a warning triangle and are shown as fol lows
according to the degree of endangerment:
z
Danger!
means that death, serious injury or considerable
damage to property will result if the appropriate
safety measures are not taken.
26
z
Warning!
means that death, serious injury or considerable
damage to property can result if the appropriate
safety measures are not taken.
z
Caution!
means that light injury or damage to property can
result if the appropriate safety measures are not
taken.
Note:
is an important piece of information about the product,
how to use the product, or the relevant section of the
documentation to which particular attention is to be
drawn.
Staff qualification requirements
Note:
Qualified personnel, as understood in this manual and in
the warning signs, are persons who are familiar with the
setup, assembly, startup, and operation of this product
and are appropriately qualified for their job. This includes,
for example, those persons who have been:
– trained or directed or authorized to switch on and off,
to ground and to label power circuits and devices or
systems in accordance with current safety engineering
standards
– trained or directed in the care and use of appropriate
safety equipment in accordance with the current
standards of safety engineering
– trained in providing first aid.

General Safety Instructions

This device is electrically operated. Adhere strictly to
the safety requirements relating to voltages applied to
the device as described in the operating instructions!
Make sure that the electrical installation meets local
or nationally applicable safety regulations.
z
Warning!
Failure to observe the information given in the
warnings could result in serious injury and/or major
damage.
Only personnel that have received appropriate
training should operate this device or work in its
immediate vicinity. The personnel must be fully
familiar with all of the warnings and maintenance
measures in these operating instructions.
Correct transport, storage, and assembly as well
as careful operation and maintenance are essential
in ensuring safe and reliable operation of this device.
Never start operation with damaged components!
Version 04 07/2014