Leuze electronic OGS 600- /CN-M12 Serie Manuel D'utilisation page 18

EN
Commissioning
Mounting
2
Mounting is generally performed using the supplied mounting devices.
Sliding blocks are provided on the sensor for attaching the mounting bracket.
These are secured to the vehicle with M5 screws.
3
The sensor must be mounted at an angle of approx. 20° (see operating instructions).
When using the supplied mounting devices, this angle is already defined.
A Optical guidance sensor
B Reflection of the reflective surface
C Automated guided vehicle (AGV)
D Direction of travel
NOTE
The mounting instructions can be found in the operating instructions,
chapter 4
NOTE
Degree of protection IP 65 is achieved only if the connectors and caps
are screwed into place!
Electrical connection
4
 Before connecting the device, please ensure that the operating volt-
age matches the value printed on the nameplate.
 Ensure that the functional earth (FE) is connected correctly. Fault-
free operation is only guaranteed if the functional earth is connected
properly.
 If faults cannot be rectified, take the device out of operation. Protect
the device from accidentally being started.
18
CAUTION!