Gaggenau VG 415 211 CA Notice De Montage page 16

en-us
Conversion to another type of gas
4.
Pull off the nozzle and O-ring for the inner burner ring
by hand. Unscrew the nozzle for the outer burner ring
(WAF 10).
5.
Check that the O-ring fits correctly in the new main
control nozzle for the inner burner ring. Fit the nozzle
to the burner pipe. Screw the new main nozzle for the
outer burner ring as far as it will go into the nozzle
retaining head.
6.
Attach the nozzle retaining head and burner pipes.
Attach the securing clips.
7.
After loosening the screw, adjust the air regulating
sleeve to the correct setting (see nozzle table).
Retighten the screw.
8.
Put the cooktop in place and tighten the screws
evenly. Put the burner parts and pan supports in
place, and ensure that they are positioned correctly.
9.
Set the pressure regulator to the correct gas
pressure.
16
Setting the Gas Type
Set the gas type via any control knob:
1.
Turn the control knob to 0 (A). Disconnect the
appliance from the power supply. Wait for at least
30 seconds (B).
2.
Reconnect the appliance (C). The illuminated ring
around the control knob will turn green for a second
and then turn yellow (D). Wait until the illuminated ring
goes out.
3.
Turn the control knob counterclockwise to position 12
(E).
4.
Turn the control knob clockwise to position 1 (F).
5.
Turn the control knob counterclockwise to position 0
(G). Wait until the illuminated ring turns yellow (H).