Briteq BT-METEOR Mode D'emploi page 9

ENGLISH
FAN Speed
On some occasions fan noise should be reduced to a minimum. Therefore you set three different fan
speed modes.
 Press the [MODE] button and use the ▼/▲ buttons until [FanSpeed] is shown on the display.
 Press the [ENTER] button to start editing.
 Use the ▼/▲ buttons to select one of the available options:
 [Auto]: the fan speed will be automatically adjusted to always have the best balance between fan
noise and performance (light output).
 [Low]: the fan speed will always be low to reduce fan noise to a minimum. (use in theatres,
conference rooms, ...). However this means that the LED temperature could become too high: in that
case the LED current will be reduced automatically to protect the LED. This means that the light output
will also be lower.
 [High]: the LED will be well cooled so maximum light output can be guaranteed under all conditions.
However this means that fan noise will be higher than usual. While used in discotheques and in hot
summertime conditions this should not be a problem.
 Once the right mode is shown on the display, press the [ENTER] button to confirm.
 Press the [MODE] button for about 2 seconds to store the setting and to return to running mode.
LED Temperature
Used to show the temperature of the LED
 Press the [MODE] button and use the ▼/▲ buttons until the display shows [LED Temp].
 Press the [ENTER] button to show the temperature on the display.
 To go back to the functions press the [MODE] button again.
If you want to go back to normal running mode: press the [MODE] button for about 2 seconds.
ERROR Information
Used to show eventual error information.
 Press the [MODE] button and use the ▼/▲ buttons until the display shows [LED Temp].
 Press the [ENTER] button to show the error information on the display.
 To go back to the functions press the [MODE] button again.
If you want to go back to normal running mode: press the [MODE] button for about 2 seconds.
Auto Test
Used to activate the internal "self-test" program which checks all possibilities of the unit.
 Press the [MODE] button and use the ▼/▲ buttons until the display shows [AutoTest].
 Press the [ENTER] button to start the internal self-test program.
 To go back to the functions press the [MODE] button.
Fixture Time
Used to show the number of working hours of the unit.
 Press the [MODE] button and use the ▼/▲ buttons until the display shows [Hours:].
 Press the [ENTER] button to show the number of working hours on the display.
 To go back to the functions press the [MODE] button.
Defaults
Used to choose between 2 sets of default settings, often used by rental companies.
Additionally you can also save and recall your own set of preferred settings.
 Press the [MODE] button and use the ▼/▲ buttons until the display shows [Defaults].
 Press the [ENTER] button to start editing.
 Use the ▼/▲ buttons to select one of the available options:
 [PRO def]: basic settings for use on professional DMX-controllers, see the list of defaults in the chart.
 [AUTO def]: basic settings for easy master/slave use, see the list of defaults in the chart.
 [USER def]: you can save / recall your own set of preferred settings.
PARAMETER name
DMX Channel mode
Show mode
Split color mode
Slave mode
No DMX mode
Sound sensitivity
BRITEQ
®
PRO defaults AUTO defaults
14 ch 5 MSL
Floor Floor
Yes
SL 1
Freeze Sound
60
7/74
USER defaults
Specified by the user
Specified by the user
Yes Specified by the user
SL 1 Specified by the user
Specified by the user
60 Specified by the user
USER MANUAL
BT-METEOR