Installation; Adjusting The Stand Height - JVC DT-V9L5 Manuel D'instructions

Installation

Caution
●
Do not rest your arm on the monitor or lean against the monitor.
●
Do not touch the LCD panel when installing the monitor.
●
Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.

Adjusting the stand height

You can select the stand height according to your preference—higher position or lower position.
To change the stand height, change the position of the screw hole used for attaching the stand.
●
When shipped from factory, the stand is attached to the higher position.
●
Before adjusting the stand height, set the monitor angle to 0°.
CAUTION
●
Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.
●
Depending on the type of external batteries, the stand cannot be attached or detached when the external battery is attached on the monitor.
●
When the stand is attached on the lower position, some types of external batteries cannot be attached to the monitor.
Screw holes for lower position
Rear panel of the monitor
Higher position
When you want to raise the position of the monitor.
Guide holes (only for attaching
to the higher position)
Monitor
6
Screw holes for higher position
Stand
Screw holes for lower position
Attachment screws