Battery Low - Cobra microTALK FRS 104 Guide D'utilisation

O P E R AT I O N
Turning On Your
microTALK Radio
®
1. Press and hold the ON/OFF POWER button
for 2 seconds. A series of audible
tones will indicate the radio is on.
ON/OFF
POWER button
®
2. Your microTALK is now in Standby mode,
ready to receive transmissions. The radio is
always in Standby mode except when the
TALK or CALL buttons are pressed.

Battery Low

When battery power is low, the BATT LOW
indicator will blink.
Auto Battery Save
Your microTALK ® radio has a unique circuit
designed to extend battery life. If there are
no transmissions within 10 seconds, the
unit will automatically switch to Battery
Save mode. This will not affect the unit's
ability to receive incoming transmissions.
3
ENGLISH
Selecting a Channel
1. With the radio on, select any of the
14 channels by pushing the CHANNEL SELECT
button up or down (NOTE: Both radios must
be tuned to the same channel
to communicate.)
CHANNEL
SELECT
button
Calling Another Person
To alert another person that you are calling:
1. Press and release the CALL button.
The other person will hear a 2-second
ringing tone. You cannot send or receive
transmissions during the 2-second call tone.
CALL
button
ENGLISH
Talking to Another Person
1. Press and hold the TALK button.
TALK button
2. With the microphone about 2 inches (5
cm) from your mouth, speak in a normal voice.
3. Release the button when you're finished
talking and listen for a response. You cannot
receive incoming calls while pressing the
TALK button.
"Roger Beep"
Confirmation Tone
Your listener will hear an audible tone when
you release the TALK button. This alerts the
other party that you are finished talking and
it is OK for them to speak.
O P E R AT I O N
Listening for a Response
When you are finished talking:
1. Release the TALK button to receive
incoming transmissions. Your microTALK
®
is always in listening mode while the TALK or
CALL buttons are not pressed.
2. Adjust the volume by pushing the
VOLUME UP or VOLUME DOWN button.
VOLUME
UP/DOWN
button
Illuminating the Display
1. Press and release the LIGHT/MAX
RANGE button to illuminate the display
for 10 seconds.
LIGHT/MAX
RANGE
button
Auto Squelch
Your microTALK ® radio is equipped with Auto
Squelch, which automatically shuts off weak
transmissions and unwanted noise due to
terrain, or conditions, or if you've reached
your maximum range limit.
4